HOW TO
Please
go to the Legal
and Privacy Information
page before attempting this How-To. |
Skill
Level
One hammer: Novice
Five hammers: Experienced |
  |
Replacing a broken sash cord
By Lou Granata
Figure 1 |
Figure 2 |
Figure 3 |
Figure 4 |
Figure 5 |
Now that the weather is getting warmer wouldn't it be nice to open that window? But the window is painted shut and the sash cord is broken. You can fix the problem with a few tools and a Saturday afternoon.
Step One
First check to see if the inside/outside of the window is painted shut. Use a window saw to cut through the paint. (figure 1) A pocket knife or a utility knife will work too, but the window saw is the safest and easiest.
Step Two
Draw a line with a pencil along the outside of the trim you are going to remove. This will give you a guide when replacing the trim. Carefully remove the window trim. (figure 2) Use a putty knife to start, then you can use a pry bar. If you are only replacing the cord on one side of the window leave the other trim in place.
Step Three
Free the window from the jam and you'll see a long slot (figure 3) on the side with a round hole where the knot goes. Remove the unbroken sash cord (most likely the cord has a tack holding the knot in place) hold on and slowly raise the cord until the weight settles or the knot comes in contact with the pulley. Now pull the broken cord out. Set the window aside.
Step Four
To expose the weight you'll have to remove the finished trim (figure 4) that surrounds the flat side of the window. Take the same care as in Step One not to damage the wood.
Step Five
Feed the cord through the pulley from the inside out. Tie a knot on the end of the cord (figure 5) and tack in place on the window. Cut the cord that you'll need, a foot longer than the bottom of the window. Replace and tack the good cord on the other side to the window. Replace the window in the jam. Tie a knot in the weight. If it's a double hung window, and the top window is not fixed tie the same knot that is tied to the working weight. With the window in place check the weight. It should not touch the bottom of the jam.
Step Six
Test slide your window up and down and you're ready to replace the trim. Sand surfaces smooth, touch up with paint where needed. Be careful not to repaint the window shut again! Clean up all chips and dust.
Some older houses could have lead paint. If you have small children test for lead before starting this project.
| Tools & Materials |
Window saw, utility knife, finishing
nails,
hammer, pry bar, sand paper, sash cord.
Sash cords come
in different thicknesses,
measure first. |
|
Where to Purchase |
W.C.Winks Hardware
200 SE Stark St
Portland
(503) 227-5536 |
| Permits & Codes? |
Log onto:
www.opdr.ci.portland.or.us |
| Average Cost |
$20.00 - $25.00 depending on
the number
of windows. |
|
Where to find information on lead paint.
The LeadLine provides Oregon callers with information and referrals for local lead programs and services. The LeadLine can be reached at (503) 988-4000 or log on to
www.leadline.org to learn more.
U.S. Department of Housing and Urban Development, Office of Lead Hazard Control has a free field guide, "Lead Paint Safety, A Field Guide for Painting, Home Maintenance, and Renovation Work." To order a copy of this guide call 1-800-424-5323 or download a copy from the HUD Office of Lead Hazard Control website at www.hud.gov/offices/lead.
United States Environmental Protection Agency, Office of Pollution Prevention and Toxics offers a free pamphlet, "Reducing Lead Hazards When Remodeling Your Home." You can download a copy and browse this site for more free information www.epa.gov/lead. |
|
