 |
|
 |
Step
6
Drill four holes. You’ll repeat this step to attach all stretchers
to the bench base. |
Step
7
Screw in one 3” deck screw on all four outside corners of
the legs. |
Step
8
Check the diagonal measurement (see top photo). Check this number
on the other side. Using a hammer tap one side until both measurements
are the same and then screw in the remaining twelve screws.
Repeat this step for the other bench front. |
 |
 |
 |
Step
9
Pre-drill four holes in the 24” side stretcher. Use the Speed
Square to plumb the stretcher and screw all four stretchers to
the two frames you just built. |
Step
10
Turn each half upside-down and place them together. |
Step
11
Use a clamp to hold the side stretcher and screw in four 3”
deck screws. Repeat this step until all side stretchers are attached. |
